3M Unisafe Nylon Visor Holder for TA500 Helmet
VH500per Each
$22.31 inc GSTTrade $20.08, save $2.23Trade accounts save 10%. Apply with your ABN
About this product
The 3M Unisafe Nylon Visor Holder is the bracket that mounts a UniSafe visor to a TA500 safety helmet, turning a hard hat into full face protection. Paired with a visor, it guards the head, eyes and face against flying particles, liquid and chemical splash, radiant heat and glare. The nylon build handles high temperatures and high impact, and it shrugs off chemical and liquid splash.
A 3 position ratchet lets the wearer lift the visor clear for a closer look and drop it back down without taking the helmet off. Peaked and unpeaked options are available to suit the helmet setup you run. Australian made, and approved for use in combination with UniSafe safety helmets, visors and earmuffs, so the whole assembly works as intended on site.
Common questions
- what helmet does the VH500 visor holder fit
- It is made for the UniSafe TA500 safety helmet. It is approved in combination with UniSafe safety helmets, visors and earmuffs.
- is the 3M Unisafe visor holder chemical resistant
- Yes, it is chemical and liquid splash resistant, and the nylon composition also handles high temperatures and high impact.
- can you lift the visor up without removing the helmet
- Yes. The 3 position ratchet system lets you raise and lower the visor while the helmet stays on.
Questions about this equipment? Send us a message and we’ll check it against the job.